• Welcome to Advance DreamBox Forum. Please login or sign up.
 

Xtrend Flashen Met Usb Stick

Started by arjanhs, December 02, 2013, 01:13:08 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

arjanhs

December 02, 2013, 01:13:08 PM Last Edit: December 02, 2013, 01:30:46 PM by ahendriks
Hoe je Clark Tech / Xtrend te flashen met een USB Stick:

1. Unzip compressed file.

(Pak de bestanden uit )

2. Copy the "ET9000" folder to a USB Pen Drive.

(Zet de ET9000 map op je usb stick)

3. Power off receiver with the mains switch on the rear.

(Zet de decoder uit met de knop aan de achterkant)

4. Connect USB Pen Drive.

(Doe de usb stick in je decoder)

5. Power on receiver with the mains switch on the rear.

(Zet de decoder aan met de knop aan de achterkant)

6. Press the OK Button on the front panel (behind the front flap).

(Druk op de OK knop van het frontpaneel Acher de klep aan de rechterkant)

Update in progress.

(Nu is de decoder aan het updaten dat zie je ook in het display)

The receiver will reboot automatically after update

(De decoder start automatisch opnieuw op en je krijgt de standaard instellingen wizzard

ahendriks

December 02, 2013, 01:31:23 PM #1 Last Edit: December 02, 2013, 01:38:55 PM by ahendriks
en nu die van de xtrend 4000... net iets anders... zie: http://tinyurl.com/orljl3y ik citeer:

QuoteHow to flash the ET4x00

USB flash drive (FAT32 formatted)
USB device (E.g. USB memory stick) In the root directory, create a folder et5x00 and copy the following 5 files to that location

Boot.bin
kernel.bin
rootfs.bin
imageversion
noforce (can for automatic Flash in "force" be renamed.)

Plug the USB media into the USB connector on the front or back either. Now power off and power on the power button on the back of the box. After switching on, the box detects when the ET5000 is firmware on the USB media. If the yellow / orange LED lights up, detected the firmware to the box. Press the UP button on the front panel to load the firmware ET5000. If the Green LED with it lights up yellow / orange, then the box leads is by loading the firmware. Please be patient, because it will take a few minutes to complete the upgrade. If the yellow / orange LED goes off loading is complete. The box will restart automatically.

In addition to the previous information, you first can make a backup with the autobackup plugin with the auto install option on. The backup should be on the root of the USB stick on which the firmware is placed before. In that way, the box will be up and running right after the reboot because all the previous settings will be restored. In this way flashing new firmware in a ET4000 will take no longer then about 5 min.

Beware: In same cases it is necessary to do a clean flash and the previous scenario can't be followed.

Note-during the upgrade not unplug or shut down the front panel has three LEDs: red, green, yellow / orange
Grt,
Alex